To measure savings, we build a baseline from your own equipment first, then meter every device before and after a change. Our client Wagamama, a multi-site restaurant group, had its results measured this way, against sub-metering data at device level, not estimated from the bill.
Energy
Energy monitoring software that proves savings
Know which sites cost you the most, down to the device
The problem
Why energy data management breaks down as your estate grows
Too much estate with too little resource
A handful of people are expected to know what's happening across hundreds of sites they rarely get to visit. Nothing gets flagged until it's already cost you money.
No way to act on what you find
Once you've spotted the waste, fixing it means a call to site, or a job for a contractor, one site at a time. That takes weeks to do across your estate.
Targets with no way to track progress
You set a reduction target, but there’s no way to check progress until the bill comes through, and by then it’s too late to change the outcome.
Vision iQ
How Vision iQ helps your energy team take control
See where the waste is
Energy iQ gives you granular energy data at site and device level, across every meter in your estate. You see your baseload and out-of-hours use, and exactly which site, or which piece of equipment, is driving your bill.
Prove the saving
Every device is metered before and after a change, so you show what a fix actually saved, without estimating or waiting for the bill. Reports break down cost and carbon by site or by asset, ready for the board or for compliance.
Control it centrally
Change a schedule or switch equipment off at one site or across the estate, from the same dashboard where you see the data. It connects to most BMS platforms and covers what yours misses. Our support bureau can handle the day-to-day.
Wagamama
It was difficult to see when individual restaurants were wasting energy. Now we have a system that works in the background, and a team that can review data and challenge performance instead of chasing it.
Tom Oliver Energy & Sustainability Project Manager, wagamama
Vision iQ™ Savings Calculator
See how fast Vision iQ™ pays for itself
Tell us how your site runs in four short steps. In about two minutes, you'll have a personalised annual saving, payback period and five-year return. It's as simple as that.
Your Vision iQ™ saving estimate
This is an indicative estimate based on benchmark assumptions for your sector, not a guaranteed saving. Clearworld will validate the figure with half-hourly data and/or a site survey before any formal savings proposal.
The ROI assumes an indicative Vision iQ investment of per site plus per site per month, set against the expected saving shown.
How it works
Three steps to control across your multi-site estate
You commit budget once the numbers from your own sites back it up.
Step 01
Free data audit
Send us your half-hourly energy data, which your energy team or supplier can pull. We find where equipment runs when it shouldn't.
Step 02
Pilot
We survey one or two sites, checking your existing controls and BMS, and fit sensors and controls out of hours. We show you the results on your own equipment.
Step 03
Rollout
You set the pace. We roll out across your other sites in phases that fit your site access windows, and our support bureau is on hand as each site goes live.
FAQs
Energy FAQs
How does Clearworld help you measure savings?
Can energy monitoring software prove energy reductions?
Yes, our energy monitoring software can prove energy reductions. Every saving is reported against your own baseline and broken down site by site or asset, so you can show the board or a client exactly what changed and why.
Can Vision iQ integrate with our existing BMS?
Yes. Vision iQ connects to most BMS platforms through open protocols and covers the sites and equipment it misses. At sites without a BMS, it runs standalone.
What is the typical payback period for Vision iQ?
Most estates see payback typically within 12 months, though it depends on the size of your estate and where the waste is concentrated.
Do we have to manage the day-to-day energy monitoring ourselves?
No, you don't have to manage the day-to-day energy monitoring yourself. Our support bureau can manage that for you, by phone or email, so your team doesn't have to chase every site.